I came across a way of building a garden fountain out of pots that I hadn’t seen before. The idea of using pots as fountains is not new but I think this version makes a wonderful addition to any garden and its very easy to do. The first thing to do is choose the pots for your fountain. The three pots will be used for a basin, a base and the larger pot that will be used as the fountain. When choosing the shape of pot for the main fountain, keep in mind how it will function and not just how it looks. Slightly tapered pots that are smooth will be quieter since the water clings to the sides as it goes down. Other pots having rings or ridges will cause the falling water to produce more sound.

Start with the large terracotta (or stone) bowl as the basin for your garden pot fountain. This will be the foundation for your fountain where the overflowing water will fall into. Using a power drill and masonry bit, drill out a hole from the center of the bowl (if necessary). Now you can run the cord from the pump out through the hole. Cover this hole with duct tape and fill it in with a car body filler. When its dry, use silicon to fill in around the cord. You should now be ready to place the pot in your desired location. Try to place this as level as possible, but its not crucial for the fountain to run properly.

The pump is housed inside the base pot that is turned upside down. The diameter of the base should match the diameter of the main large fountain pot. Cut out three or four notches around the top rim of the pot. Its easier to do this if you soak the pot in water overnight. The purpose of the notches is to let water pass in to the base to the pump.

Take a length of tubing a little longer than the height of the main fountain pot and attach it to the pump. Feed the base pot down through the hole in its bottom and seal the gap between the tubing and the hole with silicon. The whole set up should be your basin with an upside down pot sitting in the middle with a tube sticking out from the pump inside it.

Now take your fountain pot and test fit it by feeding it down over the tube and placing it on top of the base pot. If everything looks good (it should be plumb and level with the tube sticking out the top higher than the height of the pot) you can take off the fountain pot and run two thick beads of silicon around the top of the base pot. Run one bead towards the outside to help hold the pots together and one on the inside to keep water from running in between the two pots.

When it is all dry, test it by filling it with water. Adjust the height of the tubing to get the desired effect of the water bubbling up. Finish it off by filling the bottom basin pot with rocks. Enjoy your beautiful fountain!

Donald Rickerby has been working in gardens since his early childhood and has always been interested in educating others on gardening and landscaping techniques. If you would like to know more about garden pot and landscaping, visit AllGardenPots.com

Tags: DIY, fountains, garden accessories, garden fountains, garden pot, garden pots, garden projects, gardening, gardens, pots

Print This Post

Rate this post:

Related Posts:

• No related posts

This entry was posted on Wednesday, September 2nd, 2009 at 2:24 am and is filed under container gardening, gardening. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.